CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS
TM 9-2350-256-20
6 3 REPLACE ENGINE STARTER, SOLENOID RELAY, AND BRACKET Continued
WARNING
Be certain MASTER switch is OFF when working on electrical system to avoid electrical shock
and burns.
a.
REMOVAL
1
Disconnect three cables (1) and ground lead (2) by removing nut (3) and lockwasher (4).
2
Remove ground lead (2) by removing machine bolt (5) and flat washer (6).
3
Disconnect two cables (7) by removing nut (8) and lockwasher (9).
4
Disconnect lead (10) by removing nut (11) and lockwasher (12).
5
Remove U-bolt (13) by removing two self-locking nuts (14) and two clamping bars (15).
6
Remove starter (16) and gasket (17) by removing three bolts (18) and three self-locking nuts (19).
7
Remove starter cradle (20) by removing four screws (21) and four flat washers (22).
8
Remove starter support (23) by removing three machine bolts (24) and three flat washers (25).
9
Disconnect connector (26) from starter module (27).
10 Remove starter module (27) by removing two screws (28), four lockwashers (29), and two self-locking nuts (30).
11 Remove bracket (31) by removing four screws (32) and four lockwashers (33).
6
10