SECTION II: CHARGING/STARTING SYSTEM AND VEHICLE BATTERIES
TM 9-2350-256-20
NOTE
A single voltage regulator may be used as a replacement for the main engine regulator position only.
a. REMOVAL
1
Open access door (see paragraph 9-51).
2
Remove access cover (1) by removing four screws
(2) and four lockwashers (3).
3
Remove ground strap (4) by removing screw (5)
from one end of ground strap and screw (6) and
lockwasher (7) from other end of ground strap.
4
Disconnect
two
wiring
harnesses
(8)
and
two
wiring harnesses (9) from mounting bracket (10) by
removing four clamps (11), four screws (12), four
lockwashers (13), and four nuts (14).
5
Remove screw (15) and ground wire (16).
6
Remove two wiring harnesses (8) from Auxiliary
Power Unit (APU) voltage regulator (17) and two wiring harnesses (9) from main engine voltage regulator
(18).
7
Remove mounting bracket (10) by removing two screws (19), four flat washers (20), and two nuts (21).
8
Remove two mounting brackets (22) by removing four screws (23) and four lockwashers (24).
9
Remove mounting plate (25) by removing eight screws (26) and eight lockwashers (27).
NOTE
Flat washers (28) are used in single voltage regulator configurations only.
10 Remove eight insulators (29) by removing eight screws (30) and flat washers (28) if required.
6-15
