SECTION I: CHARGING/STARTING SYSTEM AND VEHICLE BATTERIES
TM 9-2350-256-20
10 Install access cover (1) using four screws (2) and
four new lockwashers (3).
11 Close access door (see paragraph 9-51).
NOTE
Follow-on maintenance:
Install air inlet doors
(see paragraph 9-56)
6-6 REPLACE VOLTAGE REGULATOR (SINGLE VOLTAGE) (11659111-1)
THIS TASK COVERS
a. Removal
b. Installation
INITIAL SET-UP
Tools:
Parts:
Equipment Condition:
Tool kit, general mechanic's Lockwasher (Appendix G,
Air inlet doors removed (see
(Appendix C, item 53)
item 115)
paragraph 9-56)
WARNING
Be certain MASTER switch is OFF when working on electrical system to avoid electrical shock and bums.
NOTE
A single voltage regulator may be used in dual voltage regulators as a replacement for the main
engine regulator only.
a. REMOVAL
1
Disconnect two connectors (1).
2
Disconnect ground strap (2) by removing screw (3)
and lockwasher (4).
3
Remove voltage regulator (5) by removing four
screws (6) and four flat washers (7).
b. INSTALLATION
1
Install voltage regulator (5) using four flat washers
(7) and four screws (6).
2
Connect ground strap (2) using new lockwasher (4)
and screw (3).
3
Connect two connectors (1).
NOTE
Follow-on maintenance:
Install air inlet doors
(see paragraph 9-56)
6-17