CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS
TM 9-2350-256-20
6-17 REPLACE/REPAIR POWER CONTROL LEVER SWITCH--Continued
WARNING
Be certain MASTER switch is OFF when working on electrical system to avoid electrical shock and bums.
a. REMOVAL
1 Disconnect two connectors (1).
2 Remove power control lever switch (2) from hydraulic system control panel (3) by removing four screws (4)
and four lockwashers (5).
3 Disconnect contact assembly (6) from sensitive switch (7).
b. DISASSEMBLY
Disassemble two lead assemblies (see Chapter 6, Section VII).
c. ASSEMBLY
Assemble two lead assemblies (see Chapter 6, Section VII).
d. INSTALLATION
1 Connect contact assembly (6) to sensitive switch (7).
2 Install power control lever switch (2) to hydraulic system control panel (3) using four screws (4) and four new
lockwashers (5).
3 Connect two connectors (1).
6-50