REPLACE/REPAIR/SERVICE NEUTRAL SAFETY SWITCH

REPLACE/REPAIR DRIVER'S PASSIVE NIGHT VIEWER SWITCH AND LIGHT AND B.O. RECEIVER SWITCH AND LIGHT

TM-9-2350-256-20 Carrier Cargo Tracked 6-Ton M548A1 (2350-01-096-9356) M548A3 2350-01-369-6081 Manual
Page Navigation
587

TM 9-2350-256-20 CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS 6-14 REPLACE/REPAIR/SERVICE NEUTRAL SAFETY SWITCH THIS TASK COVERS a. Removal b. Disassembly. c. Assembly d. Installation e. Adjustment INITIAL SET-UP Tools: Tool kit, general mechanic’s (Appendix C, item 53) Parts: Lockwashers (4) (Appendix G, item 153) Be certain MASTER switch is OFF when working on electrical system to avoid electrical shock and burns. a. REMOVAL N O T E Switch and mounting removed to show switch, normally located beneath switch panel bracket assembly. 1. Disconnect two connectors (1). 2. Remove neutral safety switch (2) by removing four screws (3) and four lockwashers b. DISASSEMBLY Disassemble wiring harness (see Chapter 6, Section VII). c. ASSEMBLY Assemble wiring harness (see Chapter 6, Section VII). d. INSTALLATION 1 Install neutral safety switch (2) using four screws (3) and four new lockwashers (4). 2 Connect two connectors (1) e. ADJUSTMENT Check adjustment screw (5) on neutral safety switch level cross shaft (6) for contact with neutral safety switch (7). It the adjustment screw is not in contact with neural safety switch, loosen locknut (8) on adjust- ment screw. adjust length of screw until neutral safety switch is engaged. Tighten locknut. 6-46

Privacy Statement
Press Release
Contact