SECTION IV: LIGHTING SYSTEM
TM 9-2350-256-20
6-24 REPLACE RIGGER'S SERVICE LIGHT SWITCH
THIS TASK COVERS
a. Removal
b. Installation
INITIAL SET-UP
Tools:
Parts:
Tool kit, general mechanic's (Appendix C, item 53)
Lockwashers (2) (Appendix G, item 116)
WARNING
Be certain MASTER switch is OFF when working on electrical system to avoid electrical shock and bums.
a. REMOVAL
1 Remove switch mount (1) and clamp (2) with
rigger's light selector switch (3) from hull wall by
removing two screws (4) and two lockwashers (5).
2 Disconnect two connectors (6) from rigger's light
selector switch (3).
3 Remove rigger's light selector switch (3) and
identification (ID) plate (7) from switch mount (1)
by removing two screws (8).
b. INSTALLATION
1 Install rigger's light selector switch (3) and ID plate
(7) on switch mount (1) using two screws (8).
2 Connect two connectors (6) to rigger's light selector
switch (3).
3 Install switch mount (1) and clamp (2) on hull wall
using two screws (4) and two new lockwashers (5).
6-57
