CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS
TM 9-2350-256-20
6-38 REPLACE/REPAIR BATTERY TO CIRCUIT BREAKER LEAD ASSEMBLY (11671811)
THIS TASK COVERS
a. Removal
b. Disassembly
c. Assembly
d. Installation
INITIAL SET-UP
Tools:
Equipment Condition:
Tool kit, general mechanic's (Appendix C, item 53)
Air inlet doors opened (see paragraph 9-56)
WARNING
Be certain MASTER switch is OFF when working on electrical systems to avoid electrical shock and bums.
Connector No.
Electrical Lead To:
Wire No.
1
Battery terminal
400
2
Circuit breaker
400
a. REMOVAL
CAUTION
Ground cables must be disconnected prior to disconnecting positive leads to prevent damage to batteries.
1 Pull back rubber insulator (3).
2
Remove lead (1) from battery terminal (4) (see
paragraph 6-4) by removing bolt (5) and nut (6).
3
Disconnect connector (2) from circuit breaker (7).
Remove lead assembly (8).
b. DISASSEMBLY
Disassemble lead assembly (8) (see Chapter 6,
Section VII).
c. ASSEMBLY
Assemble lead assembly (8) (see Chapter 6, Section
VII).
6-78
