CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS TM 9-2350-256-206-40 REPLACE/REPAIR MODULE STARTER WIRING HARNESS (11671792)-Continueda. REMOVAL1 Remove clamp (9) by removing screw (10) andlockwasher (11).2 Remove wiring harness connector (1) from enginedisconnect (12) by removing four screws (13), fourlockwashers (14), and four nuts (15).3 Remove three leads (3, 4, and 5) from startersolenoid (16) by removing two nuts (17) and twolockwashers (18).4 Disconnect connector (6) from starter module lowvoltage protective system (19).5 Disconnect three connectors (2, 7, and 8) frommain engine wiring harness (20). Remove wiringharness (21).b. DISASSEMBLYDisassemble wiring harness (21) (see Chapter 6,SectionVII).c. ASSEMBLYAssemble wiring harness (21) (see Chapter 6, SectionVII).d. INSTALLATION1 Connect three connectors (2, 7, and 8) to main engine wiring harness (20).2 Connect connector (6) to starter module low voltage protective system (19).3 Install three leads (3, 4, and 5) to starter solenoid (17) using new lockwasher (18) and nut (19).4 Install wiring harness connector (1) to engine disconnect (12) using four nuts (15), four new lockwashers(14),and four screws (13).5 Install clamp (9) using new lockwasher (11) and screw (10).6-82
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
