SECTION V: VEHICLE WIRING
TM 9-2350-256-20
a. REMOVAL
1 Disconnect two leads (1) and two leads (3) by removing two screws (4) and four lockwashers (5) from slave
receptacle (6).
2 Remove connector receptacle (7) and cap strap (8) by removing four screws (9) and four lockwashers (10).
3 Separate cap (11) from connector receptacle (7).
4 Remove two lead assemblies (2) by removing screw (12) and lockwasher (13).
b. DISASSEMBLY
Disassemble lead assemblies (see Chapter 6, Section VII).
c. ASSEMBLY
Assemble lead assemblies (see Chapter 6, Section VII).
d. INSTALLATION
1
Install two lead assemblies (2) using screw (12) and new lockwasher (13).
2
Install cap (11) to connector receptacle (7).
3
Install connector receptacle (7) and cap strap (8) using four screws (9) and four new lockwashers (10).
4 Connect two leads (1) and two leads (3) to slave receptacle (6) using two screws (4) and four new lockwashers (5).
NOTE
Follow-on maintenance: Install engine deck (see paragraph 9-51)
6-207
