SECTION V: VEHICLE WIRING
TM 9-2350-256-20
a. REMOVAL
1 Disconnect lead (1) from ground by removing screw
(3), two lockwashers (4), and nut (5).
2 Disconnect connector (2) from fire extinguisher
engine shutoff light (6) and disconnect connector
(7).
b. DISASSEMBLY
Disassemble lead assembly (see Chapter 6, Section
VII).
NOTE
Twist conductors to diode observing
proper polarity. Solder using solder comp
SN60, per QQ-S-571. A heat sink must be
used when soldering to the diode.
c. ASSEMBLY
Assemble lead assembly (see Chapter 6, Section VII).
d. INSTALLATION
1 Connect connector (2) to fire extinguisher engine shutoff light (6) and connect connector (7).
2 Connect lead (1) to ground with screw (3), two new lockwashers (4), and two nuts (5).
6-90 REPLACE/REPAIR ENGINE DISCONNECT TO STARTER GROUND WIRING
HARNESS (SINGLE VOLTAGE) (11671356)
THIS TASK COVERS
a. Removal
b. Disassembly
c. Assembly
d. Installation
INITIAL SET-UP
Tools:
Parts:
Equipment Condition:
Tool kit, general mechanic's
Lockwasher (Appendix G,
Powerplant removed (see
(Appendix C, item 53)
item 131)
paragraph 3-1)
Lockwashers (4) (Appendix
G, item 129)
6-237
