TM 9-2350-256-34-1
3-6.2
OIL PRESSURE REGULATOR VALVE
THIS TASK COVERS
a. Removal
b. Installation
INITIAL SET-UP
Part:
Equipment Condition:
• Gasket (Appendix G, item 57, TM 9-2350-256-20)
Grille doors removed (see paragraph 9-57, TM 9-
• Nuts, self-locking (2) (Appendix G, item 165, TM
2350-256-20)
2350-256-20)
a.
REMOVAL
CAUTION
Oil pressure regulator valve cover is spring loaded. Exercise care when removing cover.
1
Remove oil pressure regulator valve cover (1) by removing two self-locking nuts (2) and two flat washers (3).
2
Remove gasket (4), washer (5), plate (6), spring (7), plunger (8), and oil pressure sleeve (9).
b.
INSTALLATION
1
Install oil pressure sleeve (9), plunger (8), spring (7), plate (6), washer (5), and new gasket (4).
2
Install oil pressure regulator valve cover (1) with two new self-locking nuts (2) and two flat washers (3).
3-4.1 (3-4.2 blank)
