TM 9--2350--292--10
0093 00--1
MONITORING SYSTEM TROUBLESHOOTING
0093 00
THIS WORK PACKAGE COVERS:
CHARGE FILTER (RETURN FILTER) CLOGGED light stays on
0093 00--1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LOW OIL LEVEL indicator comes on
0093 00--1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TRANSMISSION PRESS gauge indicates less than 17 psi
0093 00--1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TRANSMISSION TEMP ° F gauge indicates 260° F (127° C) or above and SYSTEM WARNING
indicator and horn come on
0093 00--1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TURBO DUST DET indicator comes on
0093 00--2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INITIAL SETUP:
Personnel Required
Three
References
WP 0036 00
WP 0101 00
WP 0040 00
WP 0111 00
WP 0115 00
CHARGE FILTER (RETURN FILTER) CLOGGED LIGHT STAYS ON
Step 1. Remove subfloor plate above filter manifold (WP 0036 00).
Step 2. Push reset button on charge filter.
Step 3. If problem still exists, notify unit maintenance (CHARGE FILTER (RETURN FILTER) CLOGGED LIGHT
STAYS ON).
LOW OIL LEVEL INDICATOR COMES ON
CAUTION
Turn PTO CLUTCH switch OFF immediately to prevent serious damage to hydraulic
pump.
Step 1. Check compartment for leaks.
Step 2. Check reservoir and fill as specified in WP 0101 00.
Step 3. If problem still exists, notify unit maintenance (HYDRAULIC LOW OIL LEVEL WARNING LIGHT STAYS
ON. RESERVOIR IS FULL).
TRANSMISSION PRESS GAUGE INDICATES LESS THAN 17 PSI
Step 1. Check transmission oil level (WP 0101 00).
Fill as specified in WP 0101 00.
Step 2. If problem still exists, notify unit maintenance (TRANSMISSION OIL PRESSURE GAUGE FAILS TO
OPERATE).
TRANSMISSION TEMP °F GAUGE INDICATES 260°F (127°C) OR ABOVE AND SYSTEM WARNING INDICATOR
AND HORN COME ON
Step 1. Check oil cooler screens for restriction of air flow.
Clean oil cooler screens with low pressure water.
Step 2. Check transmission oil level (WP 0101 00).
Fill as specified in WP 0101 00.
Step 3. Problem occurs during towing operation or when on rough ground.
Follow procedures listed under TOWING OPERATIONS (WP 0040 00).
Step 4. If problem still exists, notify unit maintenance (TRANSMISSION OIL TEMPERATURE HIGH).
