TM 9--2350--292--10
0101 00--15
PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING
LUBRICATION INSTRUCTIONS -- CONTINUED
0101 00
TABLE 1 PREVENTIVE MAINTENANCE CHECKS AND SERVICES, BEFORE--CONTINUED
Item No.
Not Fully Mission
Capable If:
CREWMEMBER
Procedure
LOCATION
Item to Check/
Service
Interval
13
Before
Brakes
DRIVER
NOTE
Perform Item number 13a only if vehicle is
equipped with brake bleed valve and gauge
(new configuration) or modified brake ped-
al/modulation valve and higher operating
pressure (new configuration with brake
modulation).
a. Observe brake pressure gauge (1).
Approximately 25 seconds after the main
engine is started the gauge should indicate
950 psi (new configuration) or 1300 psi
(new configuration with brake modulation).
b. If gauge (1) indicates below 950 psi
(new configuration) or 1100 psi (new
configuration with brake modulation) and
brake pump motor runs continuously bleed
air from brake lines (WP 0117 00).
Brake pressure does
not reach 950 psi
(new configuration)
and brake pump mo-
tor runs continuously.
Brake pressure does
not reach 1100 to
1300 psi (new config-
uration with brake
modulation) and brake
pump motor runs con-
tinuously.
14
Before
Brakes
DRIVER
Move vehicle forward and apply brakes to
see if vehicle stops or pedal binds (WP
0017 00).
Brakes are
inoperative.
1
END OF TASK
