TM 9--2350--292--20--10210 00--2AIR CLEANER DAMPER, HANDLE AND SEALS REPLACEMENT --CONTINUED0210 00InstallationWARNING1. Clean sealing surface of damper (6) and seal mounting edges of damper housing (9) with dry--cleaning solvent.NOTEDamper seals are rubber strips that fit over lip edges ofhousing. Beveled notches are cut at specific points to fitseals around corners. Test fit seals before applyingadhesive to be sure of correct length and orientation.2. Apply adhesive (item 15, WP 0716 00) to lip edges of damper housing (9).3. Apply adhesive (item 82, WP 0716 00) to new seals (10 and 11) and install new seals (10 and 11) on damperhousing (9).4. Apply adhesive (item 82, WP 0716 00) to bearings (8) and install spring (7), two bearings (8) and damper (6) in-side damper housing (9). Position spring (7) on handle end of damper (6).5. Install damper handle (5) with socket head screw (4). Be sure handle (5) engages properly with damper (6).6. Install guard (3) with two screws (1) and two flat washers (2).Figure 2091186810712345END OF TASK
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
