TM 9--2350--292--20--1
0211 00--1
AIR CLEANER AIR DUCT ASSEMBLY AND RETAINING ROD REPLACEMENT
0211 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Materials/Parts
Lock pins (3) (item 45, WP 0718 00)
Lockwashers (2) (item 9, WP 0718 00)
Equipment Conditions
Air cleaner assembly removed (WP 0208 00)
NOTE
There are three retaining rods. This task removes/installs
only one retaining rod.
Depending on which retaining rod needs replaced, it may
or may not be necessary to remove air cleaner assembly
to access retaining rod.
Removal
1. Remove lock pin (1), straight headed pin (2) and retaining rod (3) from air duct assembly (4). Discard lock pin.
2. Remove hose assembly (5), adapter (6) and elbow (7) from air duct assembly (4).
3. Remove two screws (8), two flat washers (9), two lockwashers (10) and two nuts (11). Discard lockwashers.
4. Loosen clamp (12) on hose (13) and remove air duct assembly (4).
5. Inspect parts for damage and replace as required.
Figure 20
5
6
7
3
2
1
11
10
9
4
8
12
13
CREW
COMPARTMENT
REAR WALL
