TM 9--2350--292--20--10221 00--4FUEL/WATER SEPARATOR OPERATION TESTS -- CONTINUED0221 00Automatic Drain Test1. Place suitable metal container under fuel/water separator solenoid drain valve tube (20).2. Disconnect engine electrical harness (21) connector from fuel/water separator control box (22).3. Fill suitable metal container with water.4. Connect jumper wire (23) from suitable metal container to negative (--) side of 24 V dc power source.5. Connect fuel/water separator test harness connector (24) to control box receptacle (25).6. Connect red wire (+) (26) to positive (+) side of 24 V dc power source.7. Connect black wire (--) (27) to negative (--) side of 24 V dc power source.8. Loosen screw (12) in upper sensor probe (2) hole, loosen bleed cap (10) and check to see if fuel leaks from uppersensor probe (2) hole.9. If fuel did not leak from upper sensor probe (2) hole, remove screw (12) from upper sensor probe (2) hole andproceed to step 10. If fuel did leak from upper sensor probe (2) hole, proceed to step 13.Figure 29122SUITABLE METALCONTAINERS24V dc21222523(+)(--)2010262724
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
