TM 9--2350--292--20--1
0220 00--8
FUEL/WATER SEPARATOR FILTERS REPAIR -- CONTINUED
0220 00
Installation--Continued
11. If installing new separator, remove plug from new separator cover (26), install bleeder valve (2) removed from old
separator cover (26). Install plug in old cover (26).
12. Install control module leads and probes in fuel/water separator filter (3) (WP 0219 00).
13. Install wiring harness 3W202 on fuel/water separator filter (3) (WP 0300 00).
14. Bleed air from filter and lines by running electric fuel pump until fuel flows from bleeder valve (2). Tighten bleeder
valve (2) (TM 9--2350--292--10).
15. Check for leaks at all connections, turn off fuel pump (TM 9--2350--292--10).
Figure 29
2
3
26
END OF TASK
