TM 9--2350--292--20--10221 00--9FUEL/WATER SEPARATOR OPERATION TESTS -- CONTINUED0221 00Sequential Drain Test1. Loosen screw (12) in upper sensor probe (2) hole, loosen bleed cap (10) and check to see if fuel leaks from uppersensor probe (2) hole.2. If fuel did not leak from upper sensor probe (2) hole, remove screw (12) from upper sensor probe (2) hole andproceed to step 3. If fuel did leak from upper sensor probe (2) hole, proceed to step 6.CAUTIONDo not damage fuel/water separator gasket when remov-ing cover. Failure to comply will result in leaks to the fuel/water separator.3. Remove eight screws (15), eight lockwashers (16), eight flat washers (17) and fuel/water separator cover (18).4. Add fuel to fuel/water separator (1) until fuel leaks from upper sensor probe (2) hole. Install screw (12).5. Install fuel/water separator cover (18) with eight screws (15), eight lockwashers (16) and eight flat washers (17).Figure 2911817161512210
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
