Sequential Drain Test- (cont) - TM-9-2350-292-20-1

Sequential Drain Test- (cont) - TM-9-2350-292-20-1_1142

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
1096

TM 9--2350--292--20--1 FUEL/WATER SEPARATOR OPERATION TESTS -- CONTINUED 0221 00 Sequential Drain Test--Continued 16. Close bleed cap (10). 17. Remove screw (12) from upper sensor probe (2) hole. NOTE Sensor probes are of different lengths. Upper sensor probe is longer than lower sensor probe. 18. Install upper sensor probe retaining nut (11) and upper sensor probe (2) into fuel/water separator (1). 19. Remove screw (14) from lower sensor probe (3) hole. 20. Install lower sensor probe retaining nut (13) and lower sensor probe (3) into fuel/water separator (1). 21. Install clamp (7), three screws (4), three new lockwashers (5) and three flat washers (6) on fuel/water separator (1). 22. Tighten screw (9). 23. Service fuel/water separator (1) (WP 0220 00). Figure 29 1 9 10 7 4 5 6 12 11 13 14 2 3 END OF TASK 0221 00--13/14 blank

Privacy Statement
Press Release
Contact