TM 9--2350--292--20--10089 00--4SLOW OR NO HYDRAULIC COMPONENT OPERATION WITH HYDRAULICSELECTOR SET IN MAIN POSITION -- CONTINUED0089 00FDoes auxiliary winch, boom, and spade operate?CONTINUED FROM STEP BnoyesCONTINUED ON NEXT PAGE1. Start main engine, energize hydraulics and setengine speed to 1800 rpm (TM 9--2350--292--10).2. Attempt to operate auxiliary winch, boom, andspade.3. Shut down hydraulics and main engine(TM 9--2350--292--10).Go to Step J.GIs gauge pressure reading 440--625 psi?noyes1. Install 0--5000 psi dial pressure gauge in P test porton hydraulic control valve manifold assembly.2. Start main engine, energize hydraulics and setengine speed to 1800 rpm (TM 9--2350--292--10).Record gauge reading.3. Shut down hydraulics and main engine(TM 9--2350--292--10).Notify Direct Support Maintenance.H1. Install 0--5000 psi dial pressure gauge with 1/4--inchtee between center pump port X3 and attaching hose.2. Disconnect auxiliary winch quick--disconnects.3. Start main engine, energize hydraulics, and setengine speed to 1800 rpm(TM 9--2350--292--10).4. Place auxiliary winch control handle in inhaul position.5. Record gauge readings at port X3 and P test port.6. Shut down hydraulics and main engine(TM 9--2350--292--10).Is pressure at both gauges 3900--4100 psi?WARNINGWARNING
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business