TM 9--2350--292--20--1
0181 00--1
PAYOUT LIMIT INDICATOR FAILS TO LIGHT WHEN LESS THAN FOUR
WRAPS OF WIRE ROPE ARE LEFT ON DRUM.
0181 00
THIS WORK PACKAGE COVERS:
Payout Limit Indicator Fails To Light When Less Than Four Wraps Of Wire Rope Are Left On Drum.
INITIAL SETUP:
Tools and Special Tools
General mechanics tool kit (item 1, WP 0717 00 )
Multimeter (item 84, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Vehicle nose piece removed (WP 0497 00)
Personnel Required
Two
Does switch make contact?
Check the payout limit switch assembly to make
sure it makes contact with the upper roller spring
guide bracket.
no
yes
no
yes
A
B
CONTINUED ON NEXT PAGE
1. Turn MASTER switch ON
(TM 9--2350--292--10).
2. Hold LAMP TEST switch on accessory
control panel in the TEST position.
3. Release LAMP TEST switch and turn
MASTER switch OFF (TM 9--2350--292--10).
Does PAYOUT LIMIT indicator light?
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
Adjust payout limit
switch (WP 0502 00).
Verify fault is corrected.
Replace PAYOUT LIMIT in-
dicator lamp (WP 0244 00).
Verify fault is corrected.