TABLE 3 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, SEMIANNUALLY (cont)

TABLE 3 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, SEMIANNUALLY (cont) - TM-9-2350-292-20-1_924

TABLE 3 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, SEMIANNUALLY (cont) - TM-9-2350-292-20-1_926

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
880

TM 9--2350--292--20--1 0187 00--99 0187 00 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS -- CONTINUED TABLE 3 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, SEMIANNUALLY -- CONTINUED ITEM NO. NOT FULLY MISSION CAPABLE IF: PROCEDURE LOCATION ITEM TO CHECK/ SERVICE INTERVAL SEMIANNUALLY INTERIOR 15 Hoist Winch -- Continued k. Remove subfloor plate #13 (9) (WP 0454 00). l. Open hull drains (TM 9--2350--292--10). Place suitable container (5 gallon capacity minimum) under drain hull. m. Rotate hoist winch drum (2) until oil drain plug (10) in winch drum (2) is aligned with hole in support end plate (11). NOTE Connection points for drain tool assembly should be hand-- tightened only. 9 n. Install drain tool assembly (item 115, WP 0717 00) (12) in large threaded hole of hoist winch drum (2). Ensure that shaft (13) engages oil drain plug (10). o. Connect drain tool assembly (12) to hull drain hose (14). p. Rotate oil drain tool assembly shaft (13) until oil drains into suitable container. q. Remove sight gauge (15) and vent/fill plug (16). 2 11 10 2 (HIDDEN) 16 15 12 14 13

Privacy Statement
Press Release
Contact