TM 9--2350--292--20--2
0621 00--5
AUXILIARY POWER UNIT DUCTING REPLACEMENT (HATZ) -- CONTINUED
0621 00
Removal--Continued
NOTE
The following steps are performed with engine deck access
door adjacent to the APU open (TM 9--2350--292--10).
12. Remove two screws (32), two lockwashers (33), two flat washers (34) and cover (35). Discard lockwashers.
13. Remove grille (36) by loosening clamp (37). Slide clamp (37) back over hose (38).
14. Loosen clamp (39) at other end of hose (38). Slide clamp (39) back over hose (38). Remove hose (38). Remove
clamps (37 and 39) from hose (38).
15. Inspect parts for damage and replace as required.
Installation
1. Install hose (38) on duct (40). Slide clamp (39) over hose (38) and position clamp (39) to hold hose (38) on duct
(40). Tighten clamp (39).
2. Slide the second clamp (37) over the hose (38). Install hose (38) on grille (36) and position clamp (37) to hold
hose (38) on grille (36). Tighten clamp (37).
3. Install cover (35) and grille (36) with two screws (32), two new lockwashers (33) and two flat washers (34).
32
33
34
35
38
40
39
36
37
