TM 9--2350--292--20--2
0667 00--21
DEEP WATER FORDING KIT -- CONTINUED
0667 00
Installation--Continued
APPLICATION OF CAULKING COMPOUND
WARNING
1. Clean area around exterior and interior of fire extinguisher pull handle cover (1) and areas requiring caulking com-
pound with dry--cleaning solvent.
2. Apply sealer tape (12367083) all around areas (2) as indicated.
3. Operate main winch (TM 9--2350--292--10). Pull main winch cable (3) in until a light pressure is applied between
the clevis and the opening. Seal the exposed area around the cable, ballistic cover and extension seams cable
with caulking compound (11672186).
4. Remove left (driver’s side) armor plate (4) (WP 0511 00). Stow armor plate and screws. Discard lockwashers.
5. Install five screws (5) in left armor plate (4) holes. Seal screw (5) heads with caulking compound (11672186).
6. Seal opening and around hull front cover (6) and all around cover plate (7) and (slide rail) guides and screwheads
with caulking compound (11672186). Be certain all gaps are sealed, particularly the corners and slide rails.
7. Seal ends of cover plate (8) with caulking compound (11672186).
Figure 355
1
2
2
2
3
8
6
7
4
5
2
2
EXTERIOR
FIRE EXTINGUISHER
PULL HANDLE COVER
LEFT SIDE
VEHICLE HULL
