TM 9--2350--292--20--2
0670 00--2
EXHAUST SMOKE GENERATING SYSTEM FUEL SHUTOFF VALVE,
SOLENOID VALVE AND RELATED PARTS REPLACEMENT -- CONTINUED
0670 00
Removal--Continued
6. Remove two assembled--washer screws (14) and bracket (13) from engine. Discard assembled--washer screws.
7. Remove elbow (8) from solenoid valve (2).
8. Remove fuel shutoff valve (6) from adapter (15).
9. Remove adapter (15) from solenoid valve (2).
WARNING
10. Remove nonelectrical wire (16) from fuel shutoff valve (6). Discard nonelectrical wire.
11. Inspect parts for damage and replace as required.
Installation
NOTE
If new solenoid valve is used, remove protective covers
and felt filtering disks (if present) from inlet and outlet
ports.
Check position of electrical connector by holding solenoid
valve with inlet port to right side. Electrical connector
must be positioned directly above inlet port. To reposi-
tion, place solenoid valve in soft--jawed vise, loosen
acorn nut at top of solenoid valve, reposition electrical
connector and torque acorn nut to 50 in--lb (5.7 NSm).
1. Install adapter (15) in solenoid valve (2).
2. Install fuel shutoff valve (6) on adapter (15).
3. Install elbow (8) in solenoid valve (2).
4. Install bracket (13) on engine with two new assembled--washer screws (14).
Figure 362
8
2
6
13
14
15
16
