TM 9--2350--292--20--20370 00--3BRAKE HYDRAULIC CYLINDER REPLACEMENT (OLD CONFIGURATION) --CONTINUED0370 00Installation1. Install hydraulic cylinder (4) on threaded bracket (13).2. Secure hydraulic cylinder (4) to threaded bracket (13) with spanner plate (12).NOTEHydraulic cylinder must be flush with spanner plate within+ 0.06 in. (1.5 mm)3. Torque spanner plate (12) to 30--35 lb--ft (40.7--47.5 NSm).NOTEDisc must remain in contact with face of hydraulic cylin-der during adjustment.4. Adjust disc (11) to achieve a gap of 0.06 + .03 inch (1.5 mm) between bearings (14) and flange (15).5. Tighten nut (10). Torque nut (10) to 30--35 lb--ft (40.7--47.5 NSm).NOTEThreads of swivel must be visible through hole inthreaded rod.6. Install swivel (7) with nut (5) into threaded rod (9).7. Tighten nut (5) to lock swivel (7) in place. Torque nut (5) to 30--35 lb--ft (40.7--47.5 NSm).8. Connect brake cable assembly (8) to swivel (7).9. Tighten nut (6) to lock brake cable assembly (8) to swivel (7).Figure 17145678910111241313+--+--1514GAP0.060 .03 IN (1.5MM)FLUSH WITHIN0.060 IN (1.5MM)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
