TM 9--2350--292--20--20369 00--4BRAKE CABLE REPLACEMENT -- CONTINUED0369 00Installation--Continued11. Slide bracket (13) on brake cable assembly (3).12. Secure bracket (13) to hull with two screws (10), two new lockwashers (11) and four flat washers (12).13. Secure brake cable assembly (3) to bracket (13) using two screws (7), two new lockwashers (8) and two nuts (9).14. Install nut (6) on brake cable assembly (3).15. Tighten nuts (21 and 29) against bracket (27).WARNINGClevis must engage threads of brake cable a minimum of0.50 inch (12.7 mm) at all times. Failure to comply couldresult in cable separation from clevis causing loss of ve-hicle service brake, resulting in personnel injury or equip-ment damage.16. Install clevis (5) on brake cable assembly (3).17. Torque nut (6) to 30--35 lb--ft (40.7--47.5 NSm).18. Connect brake cable assembly (3) to plate (4) using straight headed pin with lubrication fitting (2) and new cotterpin (1).19. Lubricate straight headed pin with lubrication fitting (2).20. Perform brake control alignment and adjustment ((WP 0355 00 or WP 0356 00).Figure 1709833101153621471312272921NOTEFOLLOW--ON MAINTENANCE:Install subfloor plates #13, #16 and #20(WP 0454 00)Install powerpack (WP 0188 00)END OF TASK
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business