TM 9--2350--292--20--20369 01--1BRAKE BALL JOINT ASSEMBLY REPLACEMENT0369 01THIS WORK PACKAGE COVERS:Removal, InstallationINITIAL SETUP:Tools and Special ToolsGeneral mechanic’s tool kit (item 1, WP 0717 00)Torque wrench (item 2, WP 0717 00)Materials/PartsSafety goggles (item 93, WP 0716 00)Wiping rags (item 7, WP 0716 00)Equipment ConditionsVehicle parked on a level surface with tracks blockedand brakes released (TM 9--2350--292--10)Subfloor plates #13 and #16 removed (WP 0454 00)ReferencesTM 9--2350--292--10WARNINGWARNINGDo not work on hydraulic lines or fittings when system ispressurized. Hydraulic fluid under pressure can causepersonnel injury. Depressurize brake system by steppingon the brake pedal several times to bleed off the hydrau-lic pressure. Make sure brake pressure gauge indicateszero.Removal1. Loosen two nuts (1 and 2).2. Remove nut (1) and ball joint assembly (3) from threaded rod (4).3. Remove nut (2) and ball joint assembly (3) from brake cable assembly (5).4. Inspect parts for damage and replace as required.Installation1. Install nut (2) and ball joint assembly (3) to brake cable assembly (5). Do not thread brake cable assembly (5)past the hole in the ball joint assembly (3).2. Install nut (1) onto ball joint assembly (3) and the threaded rod (4).3. Using torque wrench, tighten nuts (1 and 2) to 30--35 lb--ft (40.7--47.5 NSm).4. Perform brake control alignment and adjustment (WP 0355 00 or WP 0356 00).NOTEFOLLOW--ON MAINTENANCE:Install subfloor plates #13 and #16 (WP 0454 00)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business