TM 9--2350--292--20--2
0369 00--3
BRAKE CABLE REPLACEMENT -- CONTINUED
0369 00
Installation
NOTE
If installing new brake cable assembly, remove nut and
swivel that come with it prior to installation.
1. Install boot (17) on brake cable assembly (3).
2. Slide brake cable assembly (3) through bulkhead into crew compartment.
3. Install nut (29) and flat washer (28) on brake cable assembly (3), slide brake cable assembly (3) through bracket
(27).
4. Install nut (21) and flat washer (22) on brake cable assembly (3). Do not tighten nuts (21 and 29) at this time.
NOTE
Bracket may be installed in front or behind hull mounting
point.
5. Install bracket (27) on vehicle hull with two screws (26), four flat washers (25), two new lockwashers (24) and two
nuts (23).
6. Install nut (18) and ball joint (19) on brake cable assembly (3).
7. Install remaining nut (18) on to ball joint (19).
8. Screw ball joint (19) into end of threaded rod (20). Ensure threads of ball joint (19) are visible through hole (30)
in threaded rod (20).
9. Secure boot (17) to brake cable assembly (3) with clamp (14), bushing (15) and new tiedown strap (16).
10. Torque two nuts (18) to 30--35 lb--ft (40.7--47.5 NSm).
3
3
15
14
16
17
18
19
18
3
20
21
22
28
29
26
25
25
24
23
27
30