TM 9--2350--292--20--2IDLER HUB ASSEMBLY REPAIR -- CONTINUED0394 00Installation--ContinuedNOTEIf rolling torque is less than 45 lb--in (5.1 NSm) or morethan 75 lb--in (8.5 NSm) repeat Removal step 1 andInstallation steps 3 through 9.10. Place a socket wrench socket on bushing (20) and use torque wrench (item 21, WP 0717 00) to rotate hub as-sembly (6), a rolling torque of 45--75 lb--in (5.1--8.5 NSm) over one full rotation is required.11. Install solid rubber idler wheel (WP 0386 00).12. Lubricate hub and arm assembly (WP 0187 00).NOTEEnd play is validated by applying a straight axial push--pull motion to hub assembly.If no end play is present, do not readjust bearings. If endplay is detected, repeat Installation Removal step 1andInstallation steps 3 through 13. This setting applies toused bearings also.13. After five mile road test, remove access cover (3), gasket (4) and spring (5) and check for end play.Figure 1866205HIDDEN34END OF TASK0394 00--7/8 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
