TM 9--2350--292--20--2
0395 00--3
IDLER ARM ASSEMBLY REPAIR -- CONTINUED
0395 00
Assembly
1. Apply a light coating of lubricant to all components.
2. Install new seal (13) with spring loaded lip facing the inside of retainer (12).
3. Install retainer (12) and new seal (13) on idler arm assembly (2).
4. Install sleeve bearing (11) and spacer (10) on idler arm assembly (2).
5. Install sleeve bearing (9) on idler arm assembly (2).
6. Install flat washer (8), key washer (7) and new key washer (5) on idler arm assembly (2).
7. Install bearing nut (6). Torque bearing nut (6) to minimum of 150 lb--ft (203 NSm) (item 2, WP 0717 00).
8. Loosen bearing nut (6) until bearing assembly can rotate by hand one full revolution. Torque nut (6) to 15--20 lb--ft
(20--27 NSm) (item 2, WP 0717 00).
9. Bend tang on new key washer (5) to secure bearing nut (6) in place.
10. Install new preformed packing (4) on spacer on idler arm assembly (2).
Figure 186
2
13
12
11
10
9
8
7
5
6
4
