TM 9--2350--292--20--2
0404 00--7
STEERING CONTROL LINKAGE (ENGINE COMPARTMENT) REPAIR --
CONTINUED
0404 00
Installation--Continued
14. Connect stud assembly (13) to bell crank (20) with screw (18) and new lockwasher (19).
15. Install bell crank (10) in vehicle hull with bolt (14), new lockwasher (15) and flat washer (16).
16. Install lubrication fitting (17) in bolt (14).
17. Connect stud assembly (13) to bell crank (10) with screw (11) and new lockwasher (12).
18. Install bushing (7), bellows (6) and clamp (5) on connecting link assembly (3). Do not tighten clamp (5).
19. Apply adhesive to bulkhead--end of bellows (6) and push the end of bellows (6) into bulkhead.
20. Connect connecting link assembly (3) to bell crank (10) with screw (8) and new lockwasher (9).
21. Connect connecting link (3) to connecting link assembly (4) with screw (1) and new lockwasher (2).
22. Measure 4.5 inches (114.3 mm) back from bulkhead and cement bushing (7) to connecting link assembly (3).
23. Secure bellows (6) to connecting link assembly (3) with clamp (5).
24. Adjust steering control linkage (WP 0405 00).
Figure 193
1
2
3
4
5
6
7
8
9
10
11
12
13
14
17
18
19
20
16
15
