TM 9--2350--292--20--20407 00--4SHIFTING CONTROL LINKAGE (ENGINE COMPARTMENT) REPAIR --CONTINUED0407 00Removal--Continued16. Remove lubrication fitting (38) from pin (39).WARNING17. Remove retaining ring (40) from pin (39). Discard retaining ring.18. Remove pin (39) and bell crank (34) from mounting bracket (41).19. Remove lubrication fitting (42) from pin (39).20. Remove screw (43) and lockwasher (44), disconnect threaded rod assembly (37) from remotecontrol lever (45). Discard lockwasher.21. Remove screw (46), lockwasher (47) and remote control lever (45) from transmission. Discard lockwasher.WARNING22. Clean all parts with dry--cleaning solvent.DisassemblyNOTEAll tubes, threaded rods, studs or connecting link assem-blies are disassembled in the same manner.1. Loosen two nuts (48) on tube, threaded rod, stud or connecting link (49).2. Remove two bearings or clevis (50) from tube, threaded rod, stud or connecting link (49).3. Remove two nuts (48) from tube, threaded rod, stud or connecting link (49).4. Inspect parts for damage and replace as required.Figure 1945048494850414039424746434445373438
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business