TM 9--2350--292--20--2
0407 00--5
SHIFTING CONTROL LINKAGE (ENGINE COMPARTMENT) REPAIR --
CONTINUED
0407 00
Assembly
NOTE
All tubes, threaded rods, studs or connecting link assem-
blies are assembled in the same manner.
Do not tighten nuts on tubes, threaded rods, studs, or
connecting link assemblies during Assembly Nuts will be
tightened during adjustment.
1. Install two nuts (48) on tube, threaded rod, stud or connecting link (49).
2. Install two bearings or clevis (50) on tube, threaded rod, stud or connecting link (49).
Installation
1. Install remote control lever (45) on transmission with screw (46) and new lockwasher (47).
2. Connect threaded rod assembly (37) to remote control lever (45) with screw (43) and new
lockwasher (44).
3. Install lubrication fitting (42) in pin (39).
4. Install bell crank (34) in mounting bracket (41) with pin (39).
WARNING
5. Install new retaining ring (40) on pin (39).
6. Install lubrication fitting (38) in pin (39).
Figure 194
50
48
49
48
50
41
40
39
42
47
46
43
44
45
37
34
38