TM 9--2350--292--20--20356 00--6BRAKE LINKAGE ALIGNMENT, ADJUSTMENT AND BLEEDING(NEW CONFIGURATION) -- CONTINUED0356 00Alignment -- ContinuedWARNINGA minimum thread engagement of 0.50 inch (12.7 mm)between brake cable assembly and ball swivel must bemaintained at all times. Failure to comply could result inassemblies separation, causing loss of vehicle servicebrake, resulting in personnel injury or vehicle damage.29. Verify thread engagement of 0.50 inch (12.7 mm) exists between ball joint (36) and threaded rod portion of brakecable assembly (2). Torque nut (35) to 30--35 lb--ft (40--47 NSm).30. Attach ball joint (36) to rod assembly (37).NOTEBrake apply levers must remain resting against externalstops during this alignment.31. With brake apply levers (7) resting against their external stops (8), adjust brake cable assembly (2) to remove allslack from brake cable assembly (2) and rear brake linkage.32. Verify a minimum of 0.50 inch (12.7 mm) thread engagement exists between threaded rod portion of ball joint (36)and rod assembly (37). Torque nut (34) to 30--35 lb--ft (40--47 NSm).Figure 1700.50 IN(12.7 MM)0.50 IN(12.7 MM)78362373435
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
