Bleeding - TM-9-2350-292-20-2

BRAKE LINKAGE ALIGNMENT, ADJUSTMENT AND BLEEDING (NEW CONFIGURATION WITH BRAKE MODULATION)

TM-9-2350-292-20-2 Recovery Vehicle Heavy Full-Tracked: M88A2 (NSN 2350-01-390-4683) (EIC:ACQ) Manual
Page Navigation
51

TM 9--2350--292--20--2 0356 00--8 BRAKE LINKAGE ALIGNMENT, ADJUSTMENT AND BLEEDING (NEW CONFIGURATION) -- CONTINUED 0356 00 Bleeding WARNING 1. Turn vehicle power switch to ON position to charge the brake system (TM 9--2350--292--10). 2. Pull brake bleed valve handle (1), hold for 30 seconds, then release. 3. Observe brake pressure gauge (2). Pressure should build up to 950 psi (6550 kPa) and brake pump motor should shut off. 4. Repeat steps 2 and 3 if pressure does not reach 950 psi (6550 kPa) and the brake pump motor does not shut off. Figure 167B 1 2 Figure 169 NOTE FOLLOW--ON MAINTENANCE: Install hull engine compartment access covers, if removed (WP 0434 00) Install subfloor access plate #6, if removed (WP 0454 00) Install powerpack, if removed (WP 0188 00) END OF TASK

Privacy Statement
Press Release
Contact