TM 1-1680-320-13&P
0016 00
NOTES
Retract cable slowly while visually verifying that cable is properly seated on
drum.
Ensure cable does not rub on sides of cable cutter barrel. Adjust as required
by aligning drum assembly in accordance with WP 0024 00.
14. Retract cable (position control pendant CABLE UP/DOWN switch to UP) approximately 10 wraps.
15. Extend cable (position control pendant CABLE UP/DOWN switch to DOWN) until SW2 switch activates and
stops motor; 5-7 wraps shall be visible on drum.
16. If less than 5 or more than 7 wraps are visible on drum then adjust limit switch drive assembly in accordance
with WP 0034 00.
17. Mark cable 10 feet from boomhead actuator assembly.
18. Retract cable (position control pendant CABLE UP/DOWN switch to UP) approximately 5 wraps.
19. Extend cable slowly (position control pendant CABLE UP/DOWN switch to DOWN) and verify that 10/240 ft.
light illuminates when mark reaches boomhead actuator assembly.
20. If 10/240 ft. light does not illuminate then adjust limit switch drive assembly in accordance with WP 0034 00.
21. Retract cable (position control pendant CABLE UP/DOWN switch to UP) until approximately 10 ft. remains
between hook assembly and boomhead actuator assembly. The 10/240 ft. warning light should illuminate.
22. If 10/240 ft. warning light does not illuminate then adjust limit switch drive assembly in accordance with WP
CAUTION
Ensure heat shrink sleeve is visible at cable hook end.
23. If required, install 3/8 inch diameter heat shrink sleeve (3-4 inch long) onto hook end of cable assembly as
follows:
a. Lubricate swaged ball on hook end of cable.
b. Slide tubing over swaged ball and align tubing with end of shank on ball.
c.
Heat tubing slightly, in place, in accordance with TM 1-1500-323-24 series.
24. Install cable hook assembly in accordance with WP 0015 00.
25. Retract remaining cable (position control pendant CABLE UP/DOWN switch to UP). Observe that cable travel
speed is reduced to 12 ft. per minute when hook assembly is 18-24 in. from boomhead actuator assembly.
26. If cable travel speed is not reduced when hook assembly is 18-24 in. from boomhead actuator assembly then
adjust limit switch drive assembly in accordance with WP 0034 00.
27. Adjust cable alignment as required by aligning drum assembly in accordance with WP 0024 00.
0016 00-11
