Section 7 STARTERS & CHARGING SYSTEMS

TABLE NO. 7

Fig. 6 - Install Spring

TM-5-4240-501-14P Special Diver Air Support System (SDASS) NSN 4220-01-292-3708 Manual
Page Navigation
91

STARTERS Rewind Starters Section 7 STARTERS & CHARGING SYSTEMS REWIND STARTERS Various rewind starter assemblies are illustrated below. Fig. 1 - Old Style Model Series: 60000, 80000, 92000, 100000 and 110000 Fig. 2 - Model Series: 60000, 80000, 92000, 100000 and 110000 Fig. 3 - Model Series: 130000, 140000, 170000, 190000, 220000 and 250000 Fig. 4 - Model Series: 140000, 170000, 190000, 250000 and 300000 Repair procedure is similar except as indicated. TO REPLACE A SPRING B Remove Spring Cut knot at starter pulley to remove rope. With rope removed, grasp outer end of rewind spring with pliers, see Fig. 5, and pull out of housing as far as possible. Turn spring 1/4 turn and remove from pulley or bend one of the tangs up and lift out starter pulley to disconnect spring. Fig. 5 - Remove Spring Install Spring Clean rewind housing. pulley and rewind spring in solvent. Wipe clean with cloth. Straighten spring to allow easier installation and restore tension. Oil spring. Insert either end of spring into blower housing slot and hook into pulley. Fig. 6. DECEMBER, 1980 1

Privacy Statement
Press Release
Contact