TM 5-4240-5501-148PSTARTERSGear Drive 12VASSEMBLY OF STARTER MOTORWhen all parts have been thoroughly inspected, lightlylubricate the bearings with #20 oil and reassemble in thefollowing manner:Slide the armature into the housing. Drive cap key mustmatch keyway in housing. Insert brushes and brushspring in their respective brush holders as shown in Fig.128.Fig. 128 - Installing BrushesInstall insulator tube on thru bolt close to motor terminal.See Fig. 129. Assemble end cap, matching key tokeyway in housing. Tighten thru bolts securely.NOTE: Insulating thrust washer must be installed onarmature shaft or shorting will occur when commutatorbars contact end cap. Fig. 129.Fig. 129 - Installing Thrust Washer and Insulator TubeAfter assembly of the starter motor drive, the startermotor is now ready for installation to the engine.38
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business