TM 9-2350-256-20-1
0054 00
CORRECTIVE ACTION Continued
6.
Reconnect wire 1 of bulkhead to engine bracket and rear fuel tank transmitter wiring harness to the
bulkhead to engine wiring harness and starter relay wiring harness. Disconnect wire 1 of bulkhead
to engine bracket and rear fuel tank transmitter wiring harness from bulkhead to APU, master relay,
and rigger's lights wiring harness. Place red lead of multimeter on male connector of wire 1 and
black lead to ground. Turn MASTER switch on, start engine, open generator cutout switch and check
for voltage. Turn engine and MASTER switch OFF, and close generator cutout switch. If voltage is
present, repair/replace wire 1 of bulkhead to APU, master relay, and rigger's lights wiring harness (see
WP 0224 00). If voltage is not present, go to step 9.
7.
Remove engine deck (see WP 0336 00). Reconnect engine voltage regulator to engine disconnect
wiring harness to engine voltage regulator. Disconnect generator power lead assembly from engine
disconnect. Place red lead of multimeter in socket A of wire 2 and black lead to ground. Turn MASTER
switch on, start engine, open generator cutout switch and check for voltage. Turn engine and MASTER
switch OFF, and close generator cutout switch. If voltage is not present, repair/replace wire 2 of engine
voltage regulator to engine disconnect wiring harness (see WP 0192 00). If voltage is present, go to
step 8.
0054 00-5
