TM 9-2350-256-20-1
0054 00
CORRECTIVE ACTION Continued
4.
Disconnect wire 1 (from socket C) of electrical accessories panel wiring harness from switch panel to
neutral safety to bulkhead wiring harness. Place red lead of multimeter on male connector of wire 1 and
black lead to ground. Turn MASTER switch on, start engine, open generator cutout switch and check
for voltage. Turn engine and MASTER switch OFF, and close generator cutout switch. If voltage
is present, repair/replace wire 1 of electrical accessories panel wiring harness (see WP 0196 00). If
voltage is not present, go to step 6.
5.
Reconnect bulkhead to engine wiring harness and starter relay wiring harness to bulkhead disconnect.
Disconnect wire 1 of bulkhead to engine bracket and rear fuel tank transmitter wiring harness (from
engine voltage regulator) from bulkhead to engine wiring harness and starter relay wiring harness.
Place red lead of multimeter on male connector of wire 1 and black lead to ground. Turn MASTER
switch on, start engine, open generator cutout switch and check for voltage. Turn engine and MASTER
switch OFF and close generator cutout switch. If voltage is present, repair/replace wire 1 of bulkhead
to engine wiring harness and starter relay wiring harness (see WP 0221 00). If voltage is not present,
go to step 6.
0054 00-4
