TM 9-2350-256-20-1
0055 00
CORRECTIVE ACTION Continued
10. Reconnect bulkhead to engine bracket and rear fuel tank transmitter to switching relay box. Disconnect
bulkhead to engine wiring harness and starter relay wiring harness from bulkhead. Place red lead of
multimeter in socket E of wire 1 and black lead to ground. Turn MASTER switch on, start engine,
close generator cutout switch and check for voltage. If voltage is present, go to step 11. If voltage is not
present, go to step 15.
11. Reconnect bulkhead to engine bracket and rear fuel tank transmitter wiring harness to switching relay
box. Disconnect electrical accessories panel wiring harness from electrical accessories panel. Place
red lead of multimeter in socket C of wire 1 and black lead to ground. Turn MASTER switch on and
check for voltage. Turn MASTER switch OFF. If voltage is present, go to step 12. If voltage is not
present, repair/replace wire 1 of electrical accessories panel wiring harness.
0055 00-8
