TM 9-2350-256-20-1
0055 00
CORRECTIVE ACTION Continued
16. Reconnect bulkhead to engine wiring harness and starter relay harness to bulkhead disconnect.
Disconnect wire 1 (from socket C) of electrical accessories panel wiring harness from switch panel to
neutral safety to bulkhead wiring harness. Place red lead of multimeter on male connector of wire 1 and
black lead to ground. Turn MASTER switch on, start engine, and check for voltage. Turn engine and
MASTER switch OFF. If voltage is present, repair/replace wire 1 of electrical accessories panel wiring
harness (see WP 0196 00). If voltage is not present, repair/replace wire 1 of switch panel to neutral
safety to bulkhead wiring harness (see WP 0203 00).
17. Reconnect bulkhead to engine wiring harness and starter relay wiring harness to bulkhead disconnect.
Disconnect wire 1 of bulkhead to engine bracket and rear fuel tank transmitter wiring harness (from
switching relay box) from bulkhead to engine wiring harness and starter relay wiring harness. Place red
lead of multimeter on male connector of wire 1. Turn MASTER switch on, start engine, open generator
cutout switch and check for voltage. Turn engine and MASTER switch OFF and close generator cutout
switch. If voltage is present, repair/replace wire 1 of bulkhead to engine wiring harness and starter
relay wiring harness (see WP 0221 00). If voltage is not present, repair/replace wire 1 of bulkhead to
engine bracket and rear fuel tank transmitter wiring harness (see WP 0223 00).
0055 00-11
