TM 9-2350-256-20-1
0055 00
CORRECTIVE ACTION Continued
14. Reconnect engine wiring harness to engine disconnect. Disconnect wire 1 of engine wiring harness
from field terminal A of generator. Place red lead of multimeter on wire 1 and black lead to ground.
Turn MASTER switch on, start engine, open generator cutout switch, and check for voltage. If voltage
is present, replace generator assembly. If voltage is not present, repair/replace wire 1 of engine wiring
harness.
15. Reconnect electrical accessories panel wiring harness to electrical accessories panel. Disconnect
bulkhead to engine harness and starter relay wiring harness from bulkhead disconnect. Place jumper
wires from pin H to socket H and pin A to socket A. Place red lead of multimeter in socket E of wire
1 and black lead to ground. Turn MASTER switch on, start engine, open generator cutout switch and
check for voltage. Turn engine and MASTER switch OFF and close generator cutout switch. If voltage
is present, go to step 16. If voltage is not present, go to step 17.
0055 00-10
