TM 9-2350-256-20-1
0055 00
CORRECTIVE ACTION Continued
12. Place red lead of multimeter in socket H of wire 1 and black lead to ground. Turn MASTER switch on,
start engine, close generator cutout switch, and check for voltage. If voltage is present, go to step 13. If
voltage is not present, go to step 18.
13. Reconnect bulkhead to engine wiring harness and starter relay wiring harness to bulkhead disconnect.
Remove engine deck (see WP 0336 00). Disconnect engine wiring harness from engine disconnect.
Place red lead of multimeter on socket C of wire 1 and black lead to ground. Turn MASTER switch on,
start engine, open generator cutout switch and check for voltage. Turn engine and MASTER switch
OFF and close generator cutout switch. If voltage is present, repair/replace engine wiring harness. If
voltage is not present, go to step 14.
0055 00-9