TM 9-2350-256-20-1
0092 00
CORRECTIVE ACTION Continued
2.
Reinstall lamp to socket. Disconnect wire T2 from indicator light. Place red lead of multimeter on wire
T2 and black lead to ground. Turn MASTER and driver's VEHICLE EXHAUST SMOKE switches
ON and check for voltage. Turn MASTER and driver's VEHICLE EXHAUST SMOKE switches OFF.
If voltage is present, replace lamp socket (see WP 0448 00). If voltage is not present, go to step 3.
3.
Reconnect wire T2 to indicator light. Disconnect driver's vehicle exhaust smoke bracket to bulkhead
connection wiring harness from driver's switch plate disconnect behind switch panel. Place red lead of
multimeter in socket B of wire 27A and black lead to ground. Turn MASTER switch on and check for
voltage. Turn MASTER switch OFF. If voltage is present, go to step 10. If voltage is not present, go to
step 4.
0092 00-4
