TM 9-2350-256-20-1
0092 00
CORRECTIVE ACTION Continued
4.
Reconnect driver's vehicle exhaust smoke bracket to bulkhead connection wiring harness to driver's
switch plate disconnect. Remove three screws (1), three lockwashers (2), ground lead (3), and flat
washer (4) and release main switch panel (5) from mounting brackets. Disconnect switch panel to gage
panel and miscellaneous switches wiring harness from main switch panel. Place a jumper wire from
pin N to socket N. Place red lead of multimeter in socket K of wire 27 and black lead to ground. Turn
MASTER switch on and check for voltage. Turn MASTER switch OFF. If voltage is present, go to step
8. If voltage is not present, go to step 5.
5.
Place red lead of multimeter in pin N of wire 10 and black lead to ground. Turn MASTER switch on
and check for voltage. Turn MASTER switch OFF. If voltage is present, go to step 6. If voltage is not
present, go to step 25.
0092 00-5
