TM 9-2350-256-20-1
0092 00
CORRECTIVE ACTION Continued
8.
Reconnect wire 27A to driver's VEHICLE EXHAUST SMOKE switch. Disconnect wire 27A of
driver's vehicle exhaust smoke bracket to bulkhead connection wiring harness at Y-connector. Place
red lead of multimeter on male connector and black lead to ground. Turn MASTER switch on and
check for voltage. Turn MASTER switch OFF. If voltage is present, repair/replace wire 27A of
driver's vehicle exhaust smoke bracket to bulkhead connection wiring harness from driver's switch to
Y-connector (see WP 0242 00). If voltage is not present, go to step 9.
9.
Reconnect wire 27A of driver's vehicle exhaust smoke bracket to bulkhead connection wiring harness
to Y-connector. Disconnect wire 27 of switch panel to gage panel and miscellaneous switches wiring
harness from Y-connector. Place red lead of multimeter on wire 27 and black lead to ground. Turn
MASTER switch on and check for voltage. Turn MASTER switch OFF. If voltage is present, replace
Y-connector (see WP 0242 00). If voltage is not present, repair/replace wire 27 of switch panel to gage
panel and miscellaneous switches wiring harness (see WP 0204 00 for dual voltage; 0205 00 for single
voltage).
0092 00-7
