TM 9-2350-256-20-1
0092 00
CORRECTIVE ACTION Continued
16. Reconnect wire 26B to driver's VEHICLE EXHAUST SMOKE switch. Disconnect wire T from
driver's VEHICLE EXHAUST SMOKE switch. Place red lead of multimeter on wire T and black
lead to ground. Turn MASTER and driver's VEHICLE EXHAUST SMOKE switches ON and check
for voltage. Turn MASTER and driver's VEHICLE EXHAUST SMOKE switches OFF. If voltage is
present, repair/replace wire T of driver's vehicle exhaust smoke bracket to bulkhead connection wiring
harness (see WP 0242 00). If voltage is not present, replace driver's VEHICLE EXHAUST SMOKE
switch (see WP 0448 00).
17. Reconnect driver's vehicle exhaust smoke bracket to bulkhead connection wiring harness to driver's
switch plate disconnect. Disconnect wire 26B from Y-connector behind gage panel. Place red lead of
multimeter on connector and black lead to ground. Turn MASTER switch on and check for voltage.
Turn MASTER switch OFF. If voltage is present, repair/replace wire 26B of driver's vehicle exhaust
smoke bracket to bulkhead connection wiring harness (see WP 0242 00). If voltage is not present, go
to step 18.
0092 00-11
