TM 9-2350-256-20-1
0092 00
CORRECTIVE ACTION Continued
14. Reconnect smoke generating system lead assembly to engine connector. Disconnect fuel solenoid
wiring harness from two fuel solenoids. Place red lead of multimeter in wire T of first fuel solenoid and
black lead to ground. Turn MASTER and driver's VEHICLE EXHAUST SMOKE switches ON and
check for voltage. Place red lead of multimeter in wire T of second fuel solenoid and check for voltage.
If voltage is present, replace fuel solenoid (see WP 0445 00). If voltage is not present, repair/replace
wire T of fuel solenoid wiring harness (see WP 0244 00).
15. Reconnect driver's vehicle exhaust smoke bracket to bulkhead connection wiring harness to driver's
switch plate disconnect. Disconnect wire 26B from driver's VEHICLE EXHAUST SMOKE switch.
Place red lead of multimeter on wire 26B and black lead to ground. Turn MASTER switch on and check
for voltage. Turn MASTER switch OFF. If voltage is present, go to step 16. If voltage is not present,
repair/replace wire 26B of driver's exhaust smoke bracket to bulkhead connection wiring harness (see
WP 0242 00).
0092 00-10
